High-Arm and Round-Arm Bowling Actions
Also known as: round arm action, round-arm bowling, high arm action in bowling, low arm action in bowling, sling arm action, arm height in bowling
A high-arm action brings the bowling arm over close to vertical at release. A round-arm action lets the ball go from lower down, with the arm sweeping out wider from the body. Both are legal as long as the ball is not thrown or bowled underarm.
Arm height is about where the hand is at release. In a high action, the hand passes close to the head, near the top of the arm's circle. In a round-arm action, the arm comes through lower and wider, in a sweeping arc. Most bowlers sit somewhere between the two.
Height changes the ball's path. A higher release sends the ball down more steeply, which tends to bring more bounce from the same length. A lower, wider release keeps the ball flatter and can make it skid on. It also changes the angle across the pitch, since the ball starts from wider of the stumps. Some batters find a low, wide release hard to pick up.
The Laws do not set an arm height. Law 21.1.2 bans underarm bowling unless both sides agree before the match. Law 21.2 bans throwing, which means the elbow straightening after the arm reaches shoulder height. A round-arm bowler must pass the same elbow test as anyone else. Changing arm height is a big change to an action, so it is best done with a qualified coach.
Example
A slinging seamer releases the ball from well wide of his head. His yorkers angle in towards the batter's toes from wide, and his bouncers rarely get above chest height.
Why it matters
Arm height shapes bounce, angle and how the ball comes at the batter. Knowing which suits your body helps you choose your lengths and variations.
Frequently asked questions
Is a round-arm bowling action legal?
Yes. The Laws set no arm height. A delivery is fair if it is not underarm and the elbow does not straighten once the arm reaches shoulder height (Laws 21.1.2 and 21.2).
Sources
Related terms
- Release Point (Bowling)The release point is where the ball leaves the bowler's hand. Its height, its place along the crease and how well it repeats all shape the ball's path. A higher release tends to make the ball bounce more from the same length.
- Bowling Action Types (Side-On, Front-On, Mixed)Pace bowling actions are grouped by how the body lines up when the back foot lands. In a side-on action the back foot is roughly parallel to the crease and the front shoulder points at the batter. In a front-on action the back foot points down the pitch and the chest faces the batter more, while a semi-open action sits in between. A mixed action starts front-on and twists the shoulders back toward side-on, and studies link it with more lower-back stress injuries.
- Illegal Bowling Action (Chucking and the 15-Degree Rule)The 15-degree rule is the ICC's limit on elbow straightening for international bowlers. A bowler's elbow may not extend more than 15 degrees from the moment the bowling arm reaches horizontal until the ball is released. The MCC Laws word it differently: the elbow must not straighten once the arm reaches shoulder height.
- Skiddy Bowler (Skidding On)A skiddy bowler is a pace bowler whose deliveries stay low and seem to hurry on after landing. The ball skids through rather than bouncing steeply. Shorter bowlers and those with a low arm are often described this way.
- BouncerA bouncer is a fast, short-pitched delivery that rears up toward the batter's head or chest. It is used to intimidate, disrupt balance, and set up the fuller ball.
Available in other languages
Put this into practice
Film one shot to see whether this is the thing to work on first — free to start.