Shaft Frequency (CPM)
Also known as: shaft frequency, cycles per minute golf shaft, shaft CPM, frequency matching, frequency matched shafts, frequency analyzer golf
Shaft frequency is how fast a clamped golf shaft vibrates after it is flexed, measured in cycles per minute (CPM). A higher number means a stiffer shaft, so fitters use it to compare flex across brands.
Flex letters such as R, S and X give a rough idea of stiffness. But no rule book defines them, so one maker's stiff can feel like another's regular. Frequency gives a number instead. A clubmaker clamps the grip end of a built club, or a shaft with a test weight, in a frequency analyser. The tip is pulled down and released. The machine counts how many times it swings up and down in a minute.
A stiffer shaft vibrates faster and gives a higher reading. Length and head weight also change the number, so readings only compare fairly on the same machine and setup. That is why fitters measure finished clubs, or shafts under the same test conditions.
Some builders use frequency to match a set. Each shorter club reads a set step higher than the one before. A club that reads well off that line may feel different from its neighbours. Frequency describes overall stiffness only. It does not show where along its length a shaft bends most, which is the job of its bend profile.
Tips by skill level
If two shafts with the same flex letter feel different, ask a fitter to measure both on a frequency analyser.
When you re-shaft one club, ask for its frequency to sit on the same slope as the rest of the set.
Example
A golfer's new driver feels softer than his old one, though both say stiff. The fitter measures both. The new one reads several cycles per minute lower, which explains the feel.
Why it matters
Frequency turns flex into a number you can compare. It helps fitters find a shaft that really matches your current one or suits your swing.
Common mistakes
- Comparing frequency readings taken on different machines or at different lengths.
- Assuming the same flex letter means the same stiffness across brands.
- Treating frequency as the whole story, when bend profile, weight and torque also shape how a shaft plays.
Frequently asked questions
What does CPM mean on a golf shaft?
Cycles per minute. It is how fast the clamped shaft vibrates. A higher number means a stiffer shaft.
Is frequency the same as flex?
It is a way to measure flex as a number. Flex letters are labels set by each maker, so frequency is more useful for comparing.
Related terms
- Shaft FlexShaft flex describes how much a shaft bends during the swing. Ratings run from L (Ladies) through A (Senior), R (Regular), S (Stiff), to X (Extra Stiff) — matched to swing speed for optimal launch.
- Kick Point (Shaft Bend Point)Kick point, or bend point, is the area of a golf shaft that bends the most during the swing. A low kick point near the clubhead tends to launch the ball a little higher. A high kick point near the grip tends to launch it lower.
- Shaft TorqueShaft torque is how much a golf shaft twists under a standard load, measured in degrees. A shaft rated 3.0° twists less than one rated 5.0°. Lower torque feels firmer and resists the face twisting. Higher torque feels softer and can suit smoother swings.
- Shaft WeightShaft weight is measured in grams. Lighter shafts generally allow faster swings, while heavier shafts often give faster swingers steadier tempo and control.
- Club FittingClub fitting uses a launch monitor to match shaft, length, lie angle, loft, and head design to a golfer's swing. Stock clubs are built for an average golfer.
Available in other languages
Related guides & benchmarks
Ready to work on your own swing?
This term is background, not something video measures. Film one swing to find the one thing to work on first — free to start.