Tipping a Shaft (Tip Trimming)
Also known as: tipping a shaft, tip trimming, tip trim golf shaft, tipped shaft, butt trimming, parallel tip shaft, taper tip shaft
Tipping a shaft means cutting length off its tip, the end that goes into the head, before fitting it. Tipping makes the shaft play stiffer, while cutting from the grip end mainly sets the club's length.
A golf shaft is usually stiffer toward the grip end and more flexible toward the tip. Cutting from the tip removes some of the softest section. So the shaft plays a little stiffer. Cutting from the butt, or grip end, mainly sets the final length. A clubmaker often does both to reach the right length and stiffness together.
Iron shafts come in two main types. A parallel-tip shaft has the same tip diameter along its first few inches. One model is used for the whole set, and the builder tips each shaft by a different amount to step the stiffness through the set. A taper-tip shaft narrows toward the tip and is made for a set club position. It usually needs little or no tipping.
Shaft makers publish trimming instructions for their shafts. Following them keeps each club true to its intended flex. Some fitters tip a shaft extra on purpose to firm it up for a faster or more aggressive swing.
Tips by skill level
Leave trimming to a qualified clubmaker. Ask whether they follow the shaft maker's trimming chart.
If a shaft feels slightly too soft, ask whether extra tip trimming could firm it before you switch models.
Example
A clubmaker builds a set with parallel-tip shafts. He trims more from the tip of the pitching wedge shaft than the 5-iron shaft, so the shorter clubs play a little stiffer.
Why it matters
How a shaft is trimmed changes how it plays. Good building keeps every club in a set feeling and flexing as it should.
Common mistakes
- Cutting a shaft only from the grip end when the maker calls for tip trimming.
- Tipping a shaft extra without checking how it changes flex.
- Assuming two shafts with the same name play the same after different trimming.
Frequently asked questions
What does tipping a golf shaft do?
It removes length from the tip end, which makes the shaft play stiffer.
What is the difference between parallel-tip and taper-tip shafts?
Parallel-tip shafts are tipped by different amounts to fit each club in a set. Taper-tip shafts are made for a set club and usually need little tip trimming.
Related terms
- Shaft FlexShaft flex describes how much a shaft bends during the swing. Ratings run from L (Ladies) through A (Senior), R (Regular), S (Stiff), to X (Extra Stiff) — matched to swing speed for optimal launch.
- Shaft Frequency (CPM)Shaft frequency is how fast a clamped golf shaft vibrates after it is flexed, measured in cycles per minute (CPM). A higher number means a stiffer shaft, so fitters use it to compare flex across brands.
- Club LengthClub length is fitted to a golfer's height, arm length, and posture at address. A mismatched length changes lie angle at impact and forces compensations that can undermine consistency more than most golfers realize.
- Kick Point (Shaft Bend Point)Kick point, or bend point, is the area of a golf shaft that bends the most during the swing. A low kick point near the clubhead tends to launch the ball a little higher. A high kick point near the grip tends to launch it lower.
- Club FittingClub fitting uses a launch monitor to match shaft, length, lie angle, loft, and head design to a golfer's swing. Stock clubs are built for an average golfer.
Available in other languages
Related guides & benchmarks
Ready to work on your own swing?
This term is background, not something video measures. Film one swing to find the one thing to work on first — free to start.