Skip to main content
Skip to main content
Intermediate

Slicing the Driver but Not the Irons

Also known as: I slice my driver but not my irons, driver slice but irons straight, irons go left driver goes right, pull irons slice driver, only slice with driver

Definition

Many golfers slice the driver while their irons fly straight or a little left. The same out-to-in swing can produce both. For a right-hander, a slice curves right. Left-handers mirror it.

This pattern confuses many players. They feel they have two swings. Often they have one swing that the two clubs show in different ways.

With irons, the ball sits further back and the club is still moving down at impact. With the driver, the ball sits forward and is struck later in the arc. For a golfer who swings out-to-in, the path can point further left by the time the club reaches a forward ball. A face that is square to the target is then open to that path, so the ball curves right. The driver also has much less loft. For the same face-to-path gap, a low-loft club tends to curve more than a lofted one. So the iron may only start a little left, while the driver slices.

Other things can add to it. The longer driver shaft gives more time for the face to stay open. Setting up with the shoulders open to a forward ball is also common. Many coaches start by checking setup and path, rather than treating the driver as a separate swing.

Tips by skill level

Beginner tip

With the driver, check that your shoulders point along your target line, not left of it.

Advanced note

Measure club path and face angle with both clubs. Work on path first, then see how the face needs to change.

Example

A right-handed golfer hits his 7-iron slightly left but slices every drive. Launch data shows the same out-to-in path with both clubs, just more open face to path with the driver.

Why it matters

Seeing it as one pattern stops you from building two different swings. The fix usually helps both clubs.

How it shows up on video

From face-on, check that the shoulders are not open at address with the driver. From down the line, compare the club's path into the ball with an iron and the driver.

Common mistakes

  • Aiming further left to allow for the slice, which can make the path more out-to-in.
  • Trying to hit the driver with a totally different swing.
  • Ignoring the iron pull, which is the same pattern in a milder form.

Frequently asked questions

Why do I slice my driver but hit my irons straight?

Often the same out-to-in swing shows more with the driver. The forward ball position and low loft both make the curve bigger.

Why do my irons go left and my driver go right?

For a right-hander, this is a classic sign of an out-to-in path. Irons tend to pull and the driver tends to slice.

Still have a question about Slicing the Driver but Not the Irons? Ask SwingVantage

Related guides & benchmarks

Put this into practice

Film one swing to see whether this is the thing to work on first — free to start.

See a sample Golf report first