Skip to main content

Automatische vertaling. Engels is de referentieversie; we verbeteren de tekst na verloop van tijd. Iets gezien dat beter kan? Laat het ons weten.

Beginner

Tee Height

Definition

Tee height is hoe hoog de bal op de tee-pen ligt. Voor een driver zou de helft van de bal boven de top van de club moeten uitsteken bij address om een positieve attack angle en hoge lancering te bevorderen.

Tee height voor de driver is de verticale positie van de bal boven de grond wanneer hij op een tee ligt — doorgaans zo ingesteld dat de evenaar van de bal gelijk staat met de bovenrand van de driverface bij address. De juiste tee height beïnvloedt direct attack angle, dynamische loft en spinpercentage, die samen trajectorie en afstand bepalen. Een bal die te laag op de tee ligt, bevordert een neerwaartse attack angle (wat spin verhoogt), terwijl een bal die te hoog ligt een opwaartse attack angle bevordert (wat spin verlaagt), maar mogelijk ook hoog contact op de face veroorzaakt (wat balsnelheid vermindert door gear-effect).

De relatie tussen tee height en prestatie is specifiek voor de swing van elke golfer. Spelers met een dalende attack angle moeten de bal hoger op de tee zetten om een neutralere of stijgende impact te bevorderen en spin te verminderen; spelers met een zeer stijgende attack angle (die significant opwaarts slaan) kunnen baat hebben bij een iets lagere tee om sky shots of gear-effect-krachtverlies door contact bovenaan de face te vermijden. Moderne launch-monitor-data maakt deze relaties concreet: het vergelijken van balsnelheid, launch angle en spinpercentage vanaf verschillende tee-hoogtes identificeert direct de optimale hoogte voor elke golfer.

Tee height beïnvloedt ook de contactlocatie op de face. Een te hoge tee gecombineerd met een stijgende attack angle produceert gear-effect door hoog-face-contact — de bal lanceert hoger dan de loft zou suggereren, met verminderde balsnelheid (omdat de sweet spot bij het midden van de face ligt, niet bovenaan). Een te lage tee gecombineerd met een dalende aanval produceert laag-face- of centercontact met hogere spin en een lagere, borende trajectorie. De ideale contactzone voor de driver is midden tot iets boven het midden, wat de juiste combinatie van tee height en attack angle vereist.

Beginner tip

For the driver, use this simple tee height rule. This means when you sole the driver normally at address, half the ball should be above the top edge of the club. If less than half is above the top, tee it higher; if most of the ball is above the top, tee it lower.

Advanced note

Use a launch monitor to test three tee heights (your normal height, 1/4 inch higher, and 1/4 inch lower) with 5 shots at each. Compare the average spin rate and ball speed — the tee height with the lowest spin combined with the highest ball speed is your optimal setting. Even a 200 RPM spin reduction from tee height adjustment can add 5–8 yards of carry at driver speeds above 100 mph.

Example

De tee zo instellen dat de helft van de bal boven de top van de driver uitsteekt, verschuift de attack angle van -1° naar +3°, wat spin vermindert en carry toevoegt — allemaal door de tee height aan te passen.

How it shows up on video

Tee height is directly visible in setup video from face-on and down-the-line angles. This means the ball should appear to sit at the top edge of the clubface when the driver is soled at address. From face-on, a too-high tee shows the ball sitting by a lot above the crown of the driver. A too-low tee shows the ball below the top edge. The consequences of incorrect tee height are visible in the trajectory. This means a skied ball (high and short) typically indicates a too-high tee with an ascending attack. A low, spinny drive indicates a too-low tee with a descending attack.

Common mistakes

  • Using the same tee height for every shot — different hole shapes, wind conditions, and shot shapes require different tee heights. A higher tee promotes a draw (reduces spin, higher launch); a lower tee promotes a controlled fade (more spin, lower launch). Adjusting tee height for specific shots adds versatility.
  • Not adjusting tee height for different drivers. This means a 460cc driver head sits higher off the ground than a 400cc head. This requires a different tee height to achieve the same face contact zone. Tee height should be calibrated to the specific driver being used.
  • Ignoring tee height as a distance variable. This means many golfers work extensively on swing changes to add distance without ever checking whether their tee height is optimal. Tee height is a free distance variable that can add 10–20 yards when optimized.
  • Using a bent or broken tee without realizing it. This means a tee that is bent or partially broken sits the ball at an unexpected angle or height. This produces unintended contact patterns. Use a new tee for every drive when precision matters.

In SwingVantage Motion Lab

SwingVantage can observe tee height from face-on setup video, noting the position of the ball relative to the top edge of the driver. The system can flag setups where the tee height appears substantially above or below the conventional guideline (ball equator at top edge) and note the potential trajectory consequences. Ball flight visible in video confirms whether the tee height is producing the intended trajectory.

Still have a question about Tee Height? Ask SwingVantage

Related guides & benchmarks

Put this into your swing

SwingVantage can spot this in your own swing — free to start.

See a sample Golf report first