Skip to main content

Tradução automática. O inglês é a versão de referência; iremos aprimorando o texto com o tempo. Viu algo para melhorar? Conte para nós.

Beginner

Altura do tee (tee height)

Definition

Altura do tee é a altura em que a bola fica no pino do tee. Para um driver, metade da bola deve ficar acima do topo do taco, no endereçamento, para promover um ângulo de ataque positivo e um lançamento alto.

A altura do tee, para o driver, é a posição vertical da bola acima do chão, quando ela está no tee — tipicamente ajustada, para que o equador da bola fique alinhado com a borda superior da face do driver, no endereçamento. A altura correta do tee influencia diretamente o ângulo de ataque, o loft dinâmico, e a taxa de giro, que juntos determinam a trajetória e a distância. Uma bola no tee baixo demais encoraja um ângulo de ataque descendente (aumentando o giro), enquanto uma bola no tee alto demais encoraja um ângulo de ataque ascendente (diminuindo o giro), mas também pode causar um contato alto na face (reduzindo a velocidade da bola, por causa do efeito de engrenagem).

A relação entre a altura do tee e o desempenho é específica ao swing de cada golfista. Jogadores com um ângulo de ataque descendente precisam colocar a bola mais alta no tee, para promover um impacto mais neutro ou ascendente, e reduzir o giro; jogadores com um ângulo de ataque muito ascendente (batendo para cima significativamente) podem se beneficiar de um tee levemente mais baixo, para evitar tacadas de sky, ou perda de potência por efeito de engrenagem, de um contato no topo da face. Dados modernos de launch monitor tornam essas relações concretas: comparar velocidade de bola, ângulo de lançamento, e taxa de giro, de diferentes alturas de tee, identifica imediatamente a altura ideal para cada golfista.

A altura do tee também influencia o local do contato na face. Um tee alto demais, combinado com um ângulo de ataque ascendente, produz efeito de engrenagem, de um contato alto na face — a bola lança mais alto do que o loft sugeriria, com velocidade de bola reduzida (porque o ponto ideal fica perto do centro da face, não do topo). Um tee baixo demais, combinado com um ataque descendente, produz um contato baixo na face, ou central, com mais giro, e uma trajetória mais baixa e enfadonha. A zona de contato ideal, para o driver, é do centro a levemente acima do centro, o que exige a combinação certa de altura de tee e ângulo de ataque.

Tips by skill level

Beginner tip

For the driver, use this simple tee height rule: when you sole the driver normally at address, half the ball should be above the top edge of the club. If less than half is above the top, tee it higher; if most of the ball is above the top, tee it lower.

Advanced note

Use a launch monitor to test three tee heights (your normal height, 1/4 inch higher, and 1/4 inch lower) with 5 shots at each. Compare the average spin rate and ball speed — the tee height with the lowest spin combined with the highest ball speed is your optimal setting. Even a 200 RPM spin reduction from tee height adjustment can add 5–8 yards of carry at driver speeds above 100 mph.

Example

Ajustar o tee, para que metade da bola espie acima do topo do driver, muda o ângulo de ataque de -1° para +3°, cortando o giro e adicionando carry — tudo a partir do ajuste da altura do tee.

How it shows up on video

Tee height is directly visible in setup video from face-on and down-the-line angles. The ball should appear to sit at the top edge of the clubface when the driver is soled at address. From face-on, a too-high tee shows the ball sitting significantly above the crown of the driver. A too-low tee shows the ball below the top edge. The consequences of incorrect tee height are visible in the trajectory. A skied ball (high and short) usually indicates a too-high tee with an ascending attack. A low, spinny drive indicates a too-low tee with a descending attack.

Common mistakes

  • Using the same tee height for every shot — different hole shapes, wind conditions, and shot shapes require different tee heights. A higher tee promotes a draw (reduces spin, higher launch); a lower tee promotes a controlled fade (more spin, lower launch). Adjusting tee height for specific shots adds versatility.
  • Not adjusting tee height for different drivers. A 460cc driver head sits higher off the ground than a 400cc head. This requires a different tee height to achieve the same face contact zone. Tee height should be calibrated to the specific driver being used.
  • Ignoring tee height as a distance variable. Many golfers work extensively on swing changes to add distance without ever checking whether their tee height is optimal. Tee height is a free distance variable that can add 10–20 yards when optimized.
  • Using a bent or broken tee without realizing it. A tee that is bent or partially broken sits the ball at an unexpected angle or height. This produces unintended contact patterns. Use a new tee for every drive when precision matters.

In SwingVantage Motion Lab

Motion Lab does not read tee height or the ball; neither is tracked in golf. Attack angle comes from a launch monitor you import, and its checks include a driver hit downward and low launch. To check tee height, film face-on at address and compare the ball with the top edge of the driver.

Still have a question about Altura do tee (tee height)? Ask SwingVantage

Related guides & benchmarks

Ready to work on your own swing?

This term is background, not something video measures. Film one swing to find the one thing to work on first — free to start.