티 높이
티 높이는 공이 티 페그 위에 얼마나 높이 놓이는지를 말한다. 드라이버의 경우, 어드레스에서 공의 절반이 클럽 위쪽 위에 위치해야 양의 어택 앵글과 높은 발사를 촉진한다.
드라이버의 티 높이는 티에 올려졌을 때 공이 지면 위 수직 위치를 말하며, 일반적으로 어드레스에서 공의 적도가 드라이버 페이스의 위쪽 가장자리와 같은 높이가 되도록 설정된다. 올바른 티 높이는 어택 앵글, 다이내믹 로프트, 스핀율에 직접 영향을 미치며, 이것들이 함께 궤적과 거리를 결정한다. 너무 낮게 올려진 공은 하강 어택 앵글을 촉진하고(스핀을 증가시킴), 너무 높게 올려진 공은 상승 어택 앵글을 촉진하지만(스핀을 감소시킴) 페이스 위쪽에서의 컨택트를 유발할 수도 있다(기어 효과로 인해 볼 스피드가 줄어듦).
티 높이와 성능 사이의 관계는 각 골퍼의 스윙에 특정적이다. 하강 어택 앵글을 가진 선수들은 더 중립적이거나 상승하는 임팩트를 촉진하고 스핀을 줄이기 위해 공을 더 높이 올려야 한다. 매우 상승하는 어택 앵글을 가진(상당히 위쪽으로 치는) 선수들은 스카이 샷이나 페이스 상단 컨택트로 인한 기어 효과 파워 손실을 피하기 위해 살짝 더 낮은 티에서 혜택을 볼 수 있다. 현대의 런치 모니터 데이터는 이러한 관계를 구체화시킨다: 서로 다른 티 높이에서의 볼 스피드, 발사각, 스핀율을 비교하면 각 골퍼에게 최적의 높이를 즉시 파악할 수 있다.
티 높이는 또한 페이스 컨택트 위치에 영향을 미친다. 너무 높은 티가 상승하는 어택 앵글과 결합되면 페이스 상단 컨택트로 인한 기어 효과가 발생한다 — 공이 로프트가 시사하는 것보다 더 높이 발사되며 볼 스피드는 줄어든다(스위트 스팟이 페이스 상단이 아니라 중앙 근처에 있기 때문). 너무 낮은 티가 하강 어택과 결합되면 페이스 하단 또는 중앙 컨택트가 발생해 더 높은 스핀과 낮고 지루한 궤적이 만들어진다. 드라이버의 이상적인 컨택트 구역은 중앙에서 살짝 위쪽이며, 이는 티 높이와 어택 앵글의 올바른 조합을 요구한다.
For the driver, use this simple tee height rule. This means when you sole the driver normally at address, half the ball should be above the top edge of the club. If less than half is above the top, tee it higher; if most of the ball is above the top, tee it lower.
Use a launch monitor to test three tee heights (your normal height, 1/4 inch higher, and 1/4 inch lower) with 5 shots at each. Compare the average spin rate and ball speed — the tee height with the lowest spin combined with the highest ball speed is your optimal setting. Even a 200 RPM spin reduction from tee height adjustment can add 5–8 yards of carry at driver speeds above 100 mph.
Example
공의 절반이 드라이버 위쪽 위로 보이도록 티를 설정하면 어택 앵글이 −1°에서 +3°로 바뀌며 스핀이 줄고 캐리가 늘어난다 — 모두 티 높이 조정만으로 이루어진 것이다.
How it shows up on video
Tee height is directly visible in setup video from face-on and down-the-line angles. This means the ball should appear to sit at the top edge of the clubface when the driver is soled at address. From face-on, a too-high tee shows the ball sitting by a lot above the crown of the driver. A too-low tee shows the ball below the top edge. The consequences of incorrect tee height are visible in the trajectory. This means a skied ball (high and short) typically indicates a too-high tee with an ascending attack. A low, spinny drive indicates a too-low tee with a descending attack.
Common mistakes
- Using the same tee height for every shot — different hole shapes, wind conditions, and shot shapes require different tee heights. A higher tee promotes a draw (reduces spin, higher launch); a lower tee promotes a controlled fade (more spin, lower launch). Adjusting tee height for specific shots adds versatility.
- Not adjusting tee height for different drivers. This means a 460cc driver head sits higher off the ground than a 400cc head. This requires a different tee height to achieve the same face contact zone. Tee height should be calibrated to the specific driver being used.
- Ignoring tee height as a distance variable. This means many golfers work extensively on swing changes to add distance without ever checking whether their tee height is optimal. Tee height is a free distance variable that can add 10–20 yards when optimized.
- Using a bent or broken tee without realizing it. This means a tee that is bent or partially broken sits the ball at an unexpected angle or height. This produces unintended contact patterns. Use a new tee for every drive when precision matters.
In SwingVantage Motion Lab
SwingVantage can observe tee height from face-on setup video, noting the position of the ball relative to the top edge of the driver. The system can flag setups where the tee height appears substantially above or below the conventional guideline (ball equator at top edge) and note the potential trajectory consequences. Ball flight visible in video confirms whether the tee height is producing the intended trajectory.
Related terms
Related guides & benchmarks
Put this into your swing
SwingVantage can spot this in your own swing — free to start.
See a sample Golf report first