Beginner

Tee Height

Definition

Tee height adalah seberapa tinggi bola berada di atas tee peg. Untuk driver, setengah bola seharusnya berada di atas bagian atas club saat address untuk mendorong attack angle positif dan launch tinggi.

Tee height untuk driver adalah posisi vertikal bola di atas tanah ketika di-tee — biasanya diatur sehingga equator bola sejajar dengan tepi atas face driver saat address. Tee height yang benar secara langsung memengaruhi angle of attack, dynamic loft, dan spin rate, yang bersama-sama menentukan lintasan dan jarak. Bola yang di-tee terlalu rendah mendorong angle of attack menurun (meningkatkan spin), sementara bola yang di-tee terlalu tinggi mendorong angle of attack menaik (mengurangi spin) tetapi juga bisa menyebabkan kontak tinggi di face (mengurangi ball speed akibat gear effect).

Hubungan antara tee height dan performa spesifik untuk swing masing-masing golfer. Pemain dengan attack angle menurun perlu men-tee bola lebih tinggi untuk mendorong impact yang lebih netral atau menaik dan mengurangi spin; pemain dengan attack angle sangat menaik (memukul ke atas secara signifikan) mungkin diuntungkan dengan tee yang sedikit lebih rendah untuk menghindari sky shot atau kehilangan tenaga akibat gear-effect dari kontak di bagian atas face. Data launch monitor modern membuat hubungan-hubungan ini konkret: membandingkan ball speed, launch angle, dan spin rate dari berbagai tee height segera mengidentifikasi tinggi optimal untuk setiap golfer.

Tee height juga memengaruhi lokasi kontak face. Tee yang terlalu tinggi dikombinasikan dengan attack angle menaik menghasilkan gear-effect dari kontak face-tinggi — bola meluncur lebih tinggi dari yang disarankan loft-nya, dengan ball speed berkurang (karena sweet spot berada dekat tengah face, bukan bagian atas). Tee yang terlalu rendah dikombinasikan dengan attack menurun menghasilkan kontak face-rendah atau tengah dengan spin lebih tinggi dan lintasan yang lebih rendah dan membosankan. Zona kontak ideal untuk driver adalah tengah hingga sedikit di atas tengah, yang membutuhkan kombinasi tee height dan attack angle yang tepat.

Beginner tip

For the driver, use this simple tee height rule. This means when you sole the driver normally at address, half the ball should be above the top edge of the club. If less than half is above the top, tee it higher; if most of the ball is above the top, tee it lower.

Advanced note

Use a launch monitor to test three tee heights (your normal height, 1/4 inch higher, and 1/4 inch lower) with 5 shots at each. Compare the average spin rate and ball speed — the tee height with the lowest spin combined with the highest ball speed is your optimal setting. Even a 200 RPM spin reduction from tee height adjustment can add 5–8 yards of carry at driver speeds above 100 mph.

Example

Mengatur tee sehingga setengah bola mengintip di atas bagian atas driver mengubah attack angle dari −1° menjadi +3°, memotong spin dan menambah carry — semuanya dari menyesuaikan tee height.

How it shows up on video

Tee height is directly visible in setup video from face-on and down-the-line angles. This means the ball should appear to sit at the top edge of the clubface when the driver is soled at address. From face-on, a too-high tee shows the ball sitting by a lot above the crown of the driver. A too-low tee shows the ball below the top edge. The consequences of incorrect tee height are visible in the trajectory. This means a skied ball (high and short) typically indicates a too-high tee with an ascending attack. A low, spinny drive indicates a too-low tee with a descending attack.

Common mistakes

Using the same tee height for every shot — different hole shapes, wind conditions, and shot shapes require different tee heights. A higher tee promotes a draw (reduces spin, higher launch); a lower tee promotes a controlled fade (more spin, lower launch). Adjusting tee height for specific shots adds versatility.
Not adjusting tee height for different drivers. This means a 460cc driver head sits higher off the ground than a 400cc head. This requires a different tee height to achieve the same face contact zone. Tee height should be calibrated to the specific driver being used.
Ignoring tee height as a distance variable. This means many golfers work extensively on swing changes to add distance without ever checking whether their tee height is optimal. Tee height is a free distance variable that can add 10–20 yards when optimized.
Using a bent or broken tee without realizing it. This means a tee that is bent or partially broken sits the ball at an unexpected angle or height. This produces unintended contact patterns. Use a new tee for every drive when precision matters.

In SwingVantage Motion Lab

SwingVantage can observe tee height from face-on setup video, noting the position of the ball relative to the top edge of the driver. The system can flag setups where the tee height appears substantially above or below the conventional guideline (ball equator at top edge) and note the potential trajectory consequences. Ball flight visible in video confirms whether the tee height is producing the intended trajectory.

Still have a question about Tee Height? Ask SwingVantage

Related guides & benchmarks

Put this into your swing

SwingVantage can spot this in your own swing — free to start.

Analyze your Golf swing — free

See a sample Golf report first