Push
Ein Push fliegt völlig gerade und endet rechts von dort, wo du gezielt hast, für einen Rechtshänder. Nichts kurvt – der Kopf reiste durch den Impact einfach nach rechts, mit der Fläche, die in dieselbe Richtung zeigte.
Ein Push im Golf (manchmal „Push Straight“ genannt) ist ein Shot, der rechts vom Ziel startet (für einen rechtshändigen Golfer) und in einer ziemlich geraden Linie nach rechts reist – ohne die Kurve eines Block-Fade oder den Hook eines Draw. Anders als ein Slice (der links startet und nach rechts kurvt) oder ein Block (der rechts startet und leicht stärker kurvt), reist ein Push in einer geraden Linie, die einfach in die falsche Richtung zielt. Das D-Plane-Modell zu verstehen hilft zu erklären, warum: Ein Push resultiert aus einem Schlägerpfad, der In-to-out ist, und einem Schlagflächenwinkel, der zum Pfad passt (quadratisch zum Pfad, aber rechts vom Ziel zeigend).
Die mechanischen Ursachen eines Push sind typischerweise eines von zwei Mustern. Das erste ist ein stark In-to-out-Pfad mit einer Fläche, die relativ zum Pfad quadratisch ist (und daher nach rechts zeigt). Das passiert, wenn ein Golfer daran arbeitet, einen Hook zu eliminieren, indem er die Fläche offen hält, was sich mit dem In-to-out-Pfad zu einem Push kombiniert. Das zweite ist ein steckengebliebener, geblockter Downswing, bei dem die hintere Seite nicht korrekt cleart und der Schlägerpfad nach rechts austritt – oft bei stärkeren, athletischeren Spielern zu sehen, deren Körperrotation kraftvoll ist, deren Arme und Schläger aber hinter der Rotation zurückfallen.
Ein Push unterscheidet sich von einem Pull (startet links, geht links) und einem Push-Slice (startet rechts, kurvt weiter rechts). Das Vorhandensein eines Push zeigt an, dass die Fläche zumindest annähernd quadratisch zum Pfad ist – sie braucht nur einen neutraleren statt In-to-out-Pfad. Spieler, die konstant pushen, sind oft nah an einem guten Swing und brauchen nur geringfügige Pfadanpassungen statt grundlegender Überholungen.
If you push shots reliably, check your finish. This means a push often produces a finish where your arms swing out to the right and your belt buckle does not fully rotate to face the target. Focus on rotating your entire body through impact. As a result, your belt buckle faces the target at the finish. This means this fuller rotation typically eliminates the stuck-arms pattern that causes pushes.
Use a launch monitor to check your club path number. This means a consistent positive path (e.g., +4° to +8°) combined with a face angle that is near zero relative to path (but positive relative to target) is the signature of a push. Reducing the path toward neutral (+1° to +2°). At the same time, maintaining face control typically resolves persistent push patterns without introducing a new miss in the other direction.
Example
Ein solide wirkender Eisenschlag, der rechts der Fahne startet und rechts bleibt, rechts vom Grün landend, ist ein Push – kein Slice, weil er nicht kurvt.
How it shows up on video
From a face-on camera angle, a push shot shows the ball starting right of the target and continuing in that direction. The telltale body pattern that produces a push is visible from face-on as the arms appearing to be "stuck" behind the body rotation. This means the hands and club exiting the impact zone to the right rather than following through toward the target. From a down-the-line angle, a push path shows the club traveling in-to-out through impact. This means crossing the target line from inside to outside rather than traveling along or slightly to the inside after impact.
Common mistakes
- Aiming left to compensate for pushes — this accommodates the bad habit rather than fixing it. If the path is in-to-out and the face is square to the path. This moves aim further left just produces a bigger push or, with a face that is now left of the path, a hook.
- Confusing a push with a block — a push travels straight right; a block travels right and may have a slight fade. Both have in-to-out paths, but the face-to-path relationship differs. Understanding which you have matters because the fix is slightly different.
- Over-correcting into a left miss (pull or hook) — adding excessive out-to-in path to fix a push will produce pulls or hooks. The target is a neutral path (0° to +2°), not a significant swing in the other direction.
- Assuming push = in-to-out path without confirming. This means some pushes come from a delayed release that starts in the right direction but the face is open at impact. A launch monitor reading is the most reliable way to confirm path and face data rather than guessing from ball flight alone.
In SwingVantage Motion Lab
SwingVantage can estimate push patterns from the ball flight direction (starting right, no curve) combined with observable body patterns from video. This means in particular arms getting stuck behind body rotation in the impact zone. Down-the-line video showing the club traveling in-to-out through impact provides the most direct path observation for diagnosing push patterns.
Related terms
- BlockingBlocking ist, wenn Arme und Schläger durch den Impact nicht vollständig releasen – die Schlagfläche wird offen gehalten, und der Ball fliegt gerade nach rechts (für einen Rechtshänder), ohne Draw-Kurve.
- In-to-OutIn-to-Out beschreibt einen Schlägerkopf, der sich beim Treffen des Balls nach rechts über die Ziellinie bewegt, für einen Rechtshänder. Es ist die Zustellungsrichtung hinter Draws, Hooks und Pushes.
- Club PathClub Path ist die horizontale Richtung, in die sich der Schlägerkopf durch den Impact bewegt, relativ zur Ziellinie, in Grad. Positiv ist In-to-out (eine Draw-Tendenz); negativ ist Out-to-in (eine Fade- oder Slice-Tendenz).
- Face-to-PathFace-to-Path ist der Unterschied zwischen Face Angle und Club Path beim Impact. Es ist die einzelne Zahl, die bestimmt, wie stark und in welche Richtung der Ball kurvt.
Related guides & benchmarks
Put this into your swing
SwingVantage can spot this in your own swing — free to start.
See a sample Golf report first